Here is a simple set of questions that you can go through to help troubleshoot your conveyor. Please call with questions. We are here to serve you.
6 Questions to Help Narrow Down the Issue | YES | NO | |
1 | Is the Horn/Alarm on the conveyor going off? | ||
2 | Is the whole Conveyor System not working? | ||
3 | Is a single conveyor or section not working? | ||
4 | Is the E-stop pull cord switches reset? | ||
5 | Does the main control panel have power? | ||
6 | Is the air compressor working and on? |
-Or-
5 Checks if Your Conveyor is NOT Working | YES | NO | |
1 | Check pull cord switches have not been pulled | ||
2 | Check any E-Stop buttons have not been pressed | ||
3 | Check the Photo Eyes Alignment | ||
Move hand across eye, if color changes, then eye is working and aligned. | |||
4 | Check Panel for Tripped Overload Switches | ||
Resetting any tripped overload switch is a temporary fix and may trip again. If so, then a major failure has occurred. |
|||
5 | Has there been an accident involving equipment contacting the conveyor? | ||
This could have caused a break in the control wires and a loss of function. |